Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit however, it's still attractive. It's not the plushest car in its class but the Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxing and comfortable driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. The following tips will aid in solving the issue whether it is constant or intermittent.
Water Damage
If you accidentally drop your key fob into an eddy, or it is wet while kayaking, canoeing or rafting or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry container whenever you are outdoors or engage in activities that expose it to a lot of water.
It's also essential to make sure that the fob is completely dried before you open it to use it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid) This is a further indication that it's been submerged.
A circuit board that is wet could cause the battery to dump its energy or even explode. If you can remove your 308 keyfob out of the water, turn the button side up and shake as much water out as you can before opening the casing. Take the battery out, and then wipe the circuit board down using a cotton swab that has been dipped in 90-percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not function include a dead battery in the coin-cell, receiver module problems, signal interference or a damaged chip. If none of these are the cause, you can try resetting the system by disconnecting the 12 volt battery for about 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology that allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the vehicle before entering. This feature is extremely useful, especially during cold winter months. However, sometimes the remote stop system stops operating due to a range of reasons, like the battery in the coin is dead.
A coin-shaped battery that is located inside the key fob has a lifespan of two to four years, depending on how often used and where it is purchased. The date of use is usually found on the packaging or listed in the instruction manual.
If the key fob stopped functioning after exposure to clean tap water it is recommended to remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If you expose it to salty or soapy water, the chip might be fried and you will have to replace the key fob in total.
If you're unsure if the battery is in good condition you can check the voltage with a multimeter set to your vehicle's voltage range and connected to the plus and minus terminals. The voltage should read approximately 12-13 volts but if it's lower, the battery needs to be replaced. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.
Faulty Receiver Module
If you don't see the "Key Detected" It could be the receiver module not working properly. It's that part that sends a signal to the car when the key fob is activated, that also acts as an immobiliser and prevents it from starting unless the correct key is used.
This could be due to a number of causes, such as water damage or simply getting old. If your Peugeot 308 key fob was exposed to dirty tap water, as in, the electronic chip inside may be damaged. In this case it is necessary to take off the battery and clean it thoroughly with isopropyl alcohol, or electronic cleaner. When the battery is clean you can attempt to test it again.
If the issue continues to persist you're probably in need of a idea to seek out a local Peugeot specialist or locksmith. They can utilize the diagnostic tool to pinpoint the problem and fix it.
The loss of your Peugeot car keys can be an extremely stressful experience. A certified auto locksmith can solve the issue in minutes. They can cut a new key and then program it into your vehicle, making sure you're off the road in the shortest time possible. Click here to locate locksmiths near you.
Faulty electronic chip
The electronic chip in the Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you could have problems starting your car or receive a message that says "anti-theft". In this case the only option is to replace the key. peugeot 207 key fob programming can provide this service in the shortest time.
The chip in the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other reasons. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned right away. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. After that, allow the battery to completely dry.
Sometimes keys may be inoperable due to radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. It can also be caused by bad weather or objects in the vicinity. If you experience this problem it is recommended to visit a Peugeot dealership.
The Peugeot 207/308 Key Fob is delicate and requires special attention. You shouldn't drop it or throw it around. If you lose something, try to find it as quickly as you can. You can reset the onboard computer by disconnection of the battery for a few minutes. Make sure you disconnect the negative cable first, and then the positive.